You follow this guide and use the software at your own risk. We, IMEI GURUS LLC will not be held responsible for anything that happens to your device. It is solely your responsibility if you choose to follow this guide and/or use the software included. By continuing with this guide and using the software or anything similar is your decision and your responsibility, not that of
IMEI GURUS LLC

 

Odin is the Samsung software that is used to push/flash firmware and firmware related items directly onto your device.

Odin is broken down into four parts, with 3 tabs. The tab in the picture, the OPTIONS tab, is the most important tab. Make sure the boxes on your copy of Odin look exactly like the boxes we have in our picture.

Next you will see BP, AP, CP, CSC. Of all the sections, AP will be the one that would be used to continue the process. This is the box you would click on to select and to load the firmware that we were able to supply for you.

Next, you are going to want to download Samsung Drivers for your PC to staart the download click link below

 Samsung drivers that can be found by here Once you download you will need to install the drivers so your computer will recognize the phone

You will also need Odin to flash the firmware to the phone click link below

 Odin software by clicking here.

Once you download Odin option the program and get ready for the next step

ON the device, you are going to want to put it in download mode like the picture you see to the right.

1.TURN PHONE OFF
2. HOLD VOLUME DOWN, HOME BUTTON AND POWER BUTTON TOGETHER.
3. WILL ASK TO HIT VOL UP TO CONTINUE
4. HIT VOLUME UP AND IT WILL ENTER DOWNLOADING MODE

Then you will take the download file and load it by clicking the AP slot, make sure you unzipped your download so the Odin program recognizes it, the program will stall for a couple minutes while it loads the firmware file this is normal. Your phone will show as COM PORT under ID COM, Once the file is loaded Click Start and the program will begin Flashing your Firmware to your device

Your Odin software should look like this, with the file loaded and the com port showing. If it does look like this, continue by pressing the start button located on the bottom right of the software